Difficulty

Moderate

Steps

7

Time Required

                          1 - 3 minutes

Sections

2

  • Battery
  • 6 steps
  • Rear Camera
  • 1 step

Flags

0

  • BackZTE ZMAX

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays.
  • Pull out the trays.

Insert a fine point tool into the hole on the top left side of the phone to remove the SIM and SD card trays.

Pull out the trays.

1024

Step 2

  • Insert a plastic opening tool into the groove between the phone’s back cover and casing.
  • Move the plastic opening tool along the edges of the phone to unclip the two pieces.

Insert a plastic opening tool into the groove between the phone’s back cover and casing.

Move the plastic opening tool along the edges of the phone to unclip the two pieces.

Step 3

  • Remove the ten 1.2mm screws with a Phillips #000 screwdriver.

Remove the ten 1.2mm screws with a Phillips #000 screwdriver.

Step 4

  • Remove the mid frame with the plastic opening tool.

Remove the mid frame with the plastic opening tool.

Step 5

  • Disconnect the battery from the motherboard.

Disconnect the battery from the motherboard.

Step 6

  • Wedge a spudger underneath the battery and gently pry upwards to remove the battery.
  • Once free from the glue, remove from device.
  • The glue holding down the battery is strong so work slow and cautiously to avoid starting a fire.

Wedge a spudger underneath the battery and gently pry upwards to remove the battery.

Once free from the glue, remove from device.

The glue holding down the battery is strong so work slow and cautiously to avoid starting a fire.

Step 7

              Rear Camera
  • Disconnect the camera from the motherboard with the flat end of a spudger.
  • Remove carefully with tweezers.

Disconnect the camera from the motherboard with the flat end of a spudger.

Remove carefully with tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Burak Cengiz

Member since: 02/15/2018

480 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team S17-G3, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S17-G3, Boczar Spring 2018 



                    USFT-BOCZAR-S18S17G3                     


                                            3 Members                     


                                            10 Guides authored