Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

3

  • Battery
  • 2 steps
  • Back Panel
  • 3 steps
  • Camera
  • 1 step

Flags

0

  • BackZTE Whirl 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The camera for this phone is used to take photos and videos. A faulty camera can result in no images or videos to be taken.

Before using this guide, be sure to inspect if there is any debris covering the camera or around it.

Before beginning, make sure your phone is completely turned off and disconnected from any power source.

What you need

Step 1

              Battery
  • Power off your phone before removing the battery.
  • Pry the cover off the back of the phone using your fingers.

Power off your phone before removing the battery.

Pry the cover off the back of the phone using your fingers.

1024

Step 2

  • Pry the battery from the phone using your fingers.

Pry the battery from the phone using your fingers.

Step 3

              Back Panel
  • Remove four 4 mm screws using a Phillips #00 screwdriver.
  • Use a tweezers to remove the lock sticker from the bottom right screw. Remove the 4 mm screw using a Phillips #00 screwdriver.

Remove four 4 mm screws using a Phillips #00 screwdriver.

Use a tweezers to remove the lock sticker from the bottom right screw. Remove the 4 mm screw using a Phillips #00 screwdriver.

Step 4

  • Insert an opening pick between the midframe and the digitizer.
  • Move the pick around the midframe to detach the midframe from the digitizer.
  • The lock button and volume buttons may fall out during this process.

Insert an opening pick between the midframe and the digitizer.

Move the pick around the midframe to detach the midframe from the digitizer.

The lock button and volume buttons may fall out during this process.

Step 5

  • Remove the midframe from the digitizer.

Remove the midframe from the digitizer.

Step 6

              Camera
  • Use the iFixit Opening Tool to disconnect the camera connector by prying up the press fit connector from the motherboard.
  • Remove the camera from the device.

Use the iFixit Opening Tool to disconnect the camera connector by prying up the press fit connector from the motherboard.

Remove the camera from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Alana Rucks

Member since: 02/04/2020

461 Reputation

                                      4 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UW Stout, Team S1-G1, Schneider-Bateman Spring 2020                        

                                                  Member of UW Stout, Team S1-G1, Schneider-Bateman Spring 2020 



                    UWSTOUT-SCHNEIDER-BATEMAN-S20S1G1                     


                                            3 Members                     


                                            10 Guides authored