Difficulty
Moderate
Steps
8
Time Required
15 - 30 minutes
Sections
3
- Battery
- 2 steps
- SIM Card
- 3 steps
- Keypad
- 3 steps
Flags
0
BackZTE Telstra T95
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the back cover using a plastic opening tool. Insert it into each corner starting at the upper left of the back cover and pushing out.
- You may also use your finger nail if you do not have a plastic opening tool at hand.
Remove the back cover using a plastic opening tool. Insert it into each corner starting at the upper left of the back cover and pushing out.
You may also use your finger nail if you do not have a plastic opening tool at hand.
1024
Step 2
- Using a plastic opening tool, push out the battery by inserting it into the small groove at the top left corner of the battery and pushing out.
- The battery snaps out of place and you can remove it using your fingers.
- When you are ready to insert a battery make sure the three copper teeth on the phone are aligned with the 3 copper dents on the battery.
Using a plastic opening tool, push out the battery by inserting it into the small groove at the top left corner of the battery and pushing out.
The battery snaps out of place and you can remove it using your fingers.
When you are ready to insert a battery make sure the three copper teeth on the phone are aligned with the 3 copper dents on the battery.
Step 3
SIM Card
Step 4
- Using your a plastic opening tool, push out the battery by inserting it into the small groove at the top left corner of the battery and pushing out.
- The battery snaps out of place and you can remove it using your fingers.
Using your a plastic opening tool, push out the battery by inserting it into the small groove at the top left corner of the battery and pushing out.
Step 5
- Remove the SIM card by placing your index finger over it and sliding it out.
- When you are ready to re-insert the SIM card make sure the pink side facing up.
Remove the SIM card by placing your index finger over it and sliding it out.
When you are ready to re-insert the SIM card make sure the pink side facing up.
Step 6
Keypad
- Unscrew the phone casing using a small screw driver. Remove the four screws on each corner on the back of the phone.
- Screw sizes are 1.42mm in width and 3.37mm in length.
Unscrew the phone casing using a small screw driver. Remove the four screws on each corner on the back of the phone.
Screw sizes are 1.42mm in width and 3.37mm in length.
Step 7
- Remove front casing by sliding a plastic opening tool between the chrome layer and the top cover.
Remove front casing by sliding a plastic opening tool between the chrome layer and the top cover.
Step 8
- The buttons should come off with the front casing but sometimes they don’t. If that is the case simply remove them using your fingers and place them with the front cover.
- If your keypad buttons are sticky you can clean them in this step.
The buttons should come off with the front casing but sometimes they don’t. If that is the case simply remove them using your fingers and place them with the front cover.
If your keypad buttons are sticky you can clean them in this step.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Dioselina M Varela
Member since: 10/25/2014
261 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Gateway, Team 1-1, Johnson Fall 2014
Member of Gateway, Team 1-1, Johnson Fall 2014
GCC-JOHNSON-F14S1G1
3 Members
12 Guides authored
