Difficulty
Moderate
Steps
6
Time Required
3 minutes
Sections
2
- Battery
- 2 steps
- Daughterboard
- 4 steps
Flags
0
BackZTE Quest n817
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Ensure that the phone is turned off before starting.
- Orient the device so that the inset on the right side of the device is facing you.
- Insert the spudger into the inset and carefully remove the back panel.
Ensure that the phone is turned off before starting.
Orient the device so that the inset on the right side of the device is facing you.
Insert the spudger into the inset and carefully remove the back panel.
1024
Step 2
- Use the ribbon to remove the exposed battery.
Use the ribbon to remove the exposed battery.
Step 3
Daughterboard
- Carefully pry open the back panel with the plastic opening tool.
Carefully pry open the back panel with the plastic opening tool.
Step 4
- Unplug the flat-top connector by lifting each side of the connector up before fully removing it from its socket.
Unplug the flat-top connector by lifting each side of the connector up before fully removing it from its socket.
Step 5
- Remove the two 2.0mm screws on either side of the daughterboard.
Remove the two 2.0mm screws on either side of the daughterboard.
Step 6
- Remove the coaxial connector that links the daughterboard to the motherboard.
Remove the coaxial connector that links the daughterboard to the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Eric Loureiro
Member since: 10/26/2018
582 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team S3-G6, Peak Fall 2018
Member of UMass Dartmouth, Team S3-G6, Peak Fall 2018
UMASSD-PEAK-F18S3G6
3 Members
10 Guides authored
