Difficulty

Difficult

Steps

8

Time Required

                          45 minutes

Sections

3

  • Battery
  • 2 steps
  • Back Panel
  • 2 steps
  • Motherboard
  • 4 steps

Flags

0

  • BackZTE Prestige 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use the iFixit opening tool to open up the device by wedging the tool under the back case and popping it open.

Use the iFixit opening tool to open up the device by wedging the tool under the back case and popping it open.

1024

Step 2

  • Remove the battery.

Remove the battery.

Step 3

              Back Panel
  • Use a Phillips #00 screwdriver to unscrew all 12 of the 3 mm Phillips screws located along the edges of the device’s back panel, as well as the blue 3mm Phillips screw labeled “ZTE” located towards the top right.

Use a Phillips #00 screwdriver to unscrew all 12 of the 3 mm Phillips screws located along the edges of the device’s back panel, as well as the blue 3mm Phillips screw labeled “ZTE” located towards the top right.

Step 4

  • Then use the iFixit opening tool and wedge it under the grey back panel and pop it off.
  • There will be a lot of resistance, apply adequate pressure.

Then use the iFixit opening tool and wedge it under the grey back panel and pop it off.

There will be a lot of resistance, apply adequate pressure.

Step 5

              Motherboard
  • Remove the three 3 mm Phillips #00 screws on the edges of the motherboard.

Remove the three 3 mm Phillips #00 screws on the edges of the motherboard.

Step 6

  • Use the iFixit opening tool to dig under the sticker where the volume and the power buttons are located on both sides.

Use the iFixit opening tool to dig under the sticker where the volume and the power buttons are located on both sides.

Step 7

  • Use the curved tweezers to gently remove the black cable running down the left side of the device and disconnect it from its socket.

Use the curved tweezers to gently remove the black cable running down the left side of the device and disconnect it from its socket.

Step 8

  • Use the curved tweezers to then unlock each of the ZIF connectors and pull the cables out.
  • The motherboard should now be able to fully disconnect from the rest of the device.

Use the curved tweezers to then unlock each of the ZIF connectors and pull the cables out.

The motherboard should now be able to fully disconnect from the rest of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Maria Stock

Member since: 01/31/2020

524 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UW Stout, Team S1-G4, Schneider-Bateman Spring 2020                        

                                                  Member of UW Stout, Team S1-G4, Schneider-Bateman Spring 2020 



                    UWSTOUT-SCHNEIDER-BATEMAN-S20S1G4                     


                                            3 Members                     


                                            14 Guides authored