Difficulty

Moderate

Steps

5

Time Required

                          7 minutes

Sections

3

  • Battery
  • 2 steps
  • Back Panel
  • 2 steps
  • Back Camera
  • 1 step

Flags

0

  • BackZTE Prestige 2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Use the iFixit opening tool to open up the device by wedging the tool under the back case and popping it open.

Use the iFixit opening tool to open up the device by wedging the tool under the back case and popping it open.

1024

Step 2

  • Remove the battery.

Remove the battery.

Step 3

              Back Panel
  • Use a Phillips #00 screwdriver to unscrew all 12 of the 3 mm Phillips screws located along the edges of the device’s back panel, as well as the blue 3mm Phillips screw labeled “ZTE” located towards the top right.

Use a Phillips #00 screwdriver to unscrew all 12 of the 3 mm Phillips screws located along the edges of the device’s back panel, as well as the blue 3mm Phillips screw labeled “ZTE” located towards the top right.

Step 4

  • Then use the iFixit opening tool and wedge it under the grey back panel and pop it off.
  • There will be a lot of resistance, apply adequate pressure.

Then use the iFixit opening tool and wedge it under the grey back panel and pop it off.

There will be a lot of resistance, apply adequate pressure.

Step 5

              Back Camera
  • Use the iFixit opening pick and wedge it under the press fit connector beside the camera located at the top center of the device to pop it off.
  • Remove the camera.
  • The camera cable near the press fit connector is delicate, ripping it will cause permanent damage.
  • The base of the camera may be glued down which may lead to accidental ripping during removal. Use the flat end of a metal spudger to pry it up if necessary.

Use the iFixit opening pick and wedge it under the press fit connector beside the camera located at the top center of the device to pop it off.

Remove the camera.

The camera cable near the press fit connector is delicate, ripping it will cause permanent damage.

The base of the camera may be glued down which may lead to accidental ripping during removal. Use the flat end of a metal spudger to pry it up if necessary.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Maria Stock

Member since: 01/31/2020

524 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UW Stout, Team S1-G4, Schneider-Bateman Spring 2020                        

                                                  Member of UW Stout, Team S1-G4, Schneider-Bateman Spring 2020 



                    UWSTOUT-SCHNEIDER-BATEMAN-S20S1G4                     


                                            3 Members                     


                                            14 Guides authored