Zte Avail 2 Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Battery
2 steps
Camera
6 steps

Flags

BackZTE Avail 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Once you successfully replace the camera lens, your device should now take higher quality pictures and videos.

What you need

Step 1

              Battery

Before disassembling your ZTE Avail 2, be sure it is powered off.
Remove the back cover using the notch at the bottom of the device.
Pull the back cover from the front panel gently to remove it.

Before disassembling your ZTE Avail 2, be sure it is powered off.

Remove the back cover using the notch at the bottom of the device.

Pull the back cover from the front panel gently to remove it.

1024

Step 2

Remove the battery by the notch in the back plate.

Remove the battery by the notch in the back plate.

Step 3

              Camera

Using your J00 screwdriver, unscrew each of the 8 Philips head screws from the black plate of the device.

Using your J00 screwdriver, unscrew each of the 8 Philips head screws from the black plate of the device.

Step 4

Using the spudger tool, pull up from underneath the back plate and pop off the piece.

Using the spudger tool, pull up from underneath the back plate and pop off the piece.

Step 5

Using the tweezers remove the 4 orange ribbon cables. Do this by lifting their corresponding black connectors and pulling the ribbon out.

Using the tweezers remove the 4 orange ribbon cables. Do this by lifting their corresponding black connectors and pulling the ribbon out.

Step 6

On the left side you will see a cellular antenna cable wire. Remove this wire by gently pulling it off.

On the left side you will see a cellular antenna cable wire. Remove this wire by gently pulling it off.

Step 7

Lift up the motherboard, this may require some force because it is held on by adhesive.
This will allow you to access the camera and the camera mount.

Lift up the motherboard, this may require some force because it is held on by adhesive.

This will allow you to access the camera and the camera mount.

Step 8

Where you can see the front of the camera lightly push on the camera to remove the camera from its holding. The camera will come through the back.
Once out of the holding remove the clip holding it to the underside of the motherboard. Now the camera is removed.
Once the old camera is removed replace it with the new camera to complete the repair.

Where you can see the front of the camera lightly push on the camera to remove the camera from its holding. The camera will come through the back.

Once out of the holding remove the clip holding it to the underside of the motherboard. Now the camera is removed.

Once the old camera is removed replace it with the new camera to complete the repair.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 4 other contributors

                    haugaustin

Member since: 09/22/2015

355 Reputation

                                      1 Guide authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       University of Alabama, Team 1-6, Sydow campbell Fall 2015                        

                                                  Member of University of Alabama, Team 1-6, Sydow campbell Fall 2015 



                    UA-SYDOW CAMPBELL-F15S1G6                     


                                            5 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team