Difficulty
Very easy
Steps
3
Time Required
5 minutes
Sections
1
- Storage Drive
- 3 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackZotac EN970
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Opening your machine
- Zotac uses thumb screws to secure the case. No tools required!
- After you remove the thumb screws, just slide the bottom cover away from you and lift it away.
Zotac uses thumb screws to secure the case. No tools required!
After you remove the thumb screws, just slide the bottom cover away from you and lift it away.
1024
Step 2
Insert your drive
- The EN970 has three hard drive connectors: 2 2.5" bays and 1 M.2 bay.
- There are thumb screws for the 2.5" drives that secure plastic caddies that snap onto your drive
The EN970 has three hard drive connectors: 2 2.5" bays and 1 M.2 bay.
There are thumb screws for the 2.5" drives that secure plastic caddies that snap onto your drive
Step 3
M.2 Drive
- The M.2 drive requires a phillips screwdriver for installation. Your ZBOX should have two screws inserted in two of the three pegs.
- Remove the screws, insert your drive and use one screw to secure it. Be sure not to over-tighten.
The M.2 drive requires a phillips screwdriver for installation. Your ZBOX should have two screws inserted in two of the three pegs.
Remove the screws, insert your drive and use one screw to secure it. Be sure not to over-tighten.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
9 other people completed this guide.
Author
with 2 other contributors
zdowns1
Member since: 11/21/2013
247 Reputation
2 Guides authored
Badges:
11
+8 more badges