Difficulty
Moderate
Steps
3
Time Required
15 - 20 minutes
Sections
1
- Sensor
- 3 steps
Flags
0
BackZoomer Show Pony
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Sensor
- Flip over your pony and find the screws marked in red.
- Remove these screws with a 3.0 Triangle screw bit. Don’t worry about keeping them seperated because they are all the same size.
- When the screws are removed the head and rear legs should be removable. Be careful to not pull everything apart to much because the head and legs are all connected to the motherboard.
Flip over your pony and find the screws marked in red.
Remove these screws with a 3.0 Triangle screw bit. Don’t worry about keeping them seperated because they are all the same size.
When the screws are removed the head and rear legs should be removable. Be careful to not pull everything apart to much because the head and legs are all connected to the motherboard.
1024
Step 2
- Remove the wires connecting the head and leg sections. We will disconnect all of the wire connections in this step and they will need to be re-connected at the end, so be careful when disconnecting.
- Now that the wires have been disconnected, the head and back legs should be free to place aside
- Remove the black bar by unscrewing the two triangle screws marked in yellow. These screws are recessed into the black bar so you may need an extender for your triangle bit.
Remove the wires connecting the head and leg sections. We will disconnect all of the wire connections in this step and they will need to be re-connected at the end, so be careful when disconnecting.
Now that the wires have been disconnected, the head and back legs should be free to place aside
Remove the black bar by unscrewing the two triangle screws marked in yellow. These screws are recessed into the black bar so you may need an extender for your triangle bit.
Step 3
- Take out the two clips keeping the motherboard in place but applying upwards pressure on them.
- Remove the motherboard and replace. The sensors are soldered on to the motherboard so the whole board must be replaced.
Take out the two clips keeping the motherboard in place but applying upwards pressure on them.
Remove the motherboard and replace. The sensors are soldered on to the motherboard so the whole board must be replaced.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Cedric Bossa
Member since: 10/02/2017
118 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
USF Tampa, Team S20-G5, Passmore Spring 2018
Member of USF Tampa, Team S20-G5, Passmore Spring 2018
USFT-PASSMORE-S18S20G5
4 Members
5 Guides authored