Zoomer Meowzies Chest Senor Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          7 - 15 minutes

Sections

Legs
3 steps
Chest Senor
4 steps

Flags

BackZoomer Meowzies
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Legs

Using the Triangle driver remove the four 7.5 mm screws.
The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

Using the Triangle driver remove the four 7.5 mm screws.

The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

1024

Step 2

Turn the device so that the the device is on its side.
Hold the back and belly on the device and gently pull apart.
Pulling with too much force might damage a few cables inside, so caution is needed.

Turn the device so that the the device is on its side.

Hold the back and belly on the device and gently pull apart.

Pulling with too much force might damage a few cables inside, so caution is needed.

Step 3

With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

Step 4

              Chest Senor

Carefully pry the ribbon cable from the connector.
Though we find it easier to use our fingers, the pry-tools may be useful.

Carefully pry the ribbon cable from the connector.

Though we find it easier to use our fingers, the pry-tools may be useful.

Step 5

For easier access to the sensor, tilt and pull the sensor away from the body.

For easier access to the sensor, tilt and pull the sensor away from the body.

Step 6

To remove the sensors, use a soldering iron to solder the two points and remove the red and black wires from the reverse side.
The soldering iron is very hot, so take caution not to touch it directly in order to avoid burns.

To remove the sensors, use a soldering iron to solder the two points and remove the red and black wires from the reverse side.

The soldering iron is very hot, so take caution not to touch it directly in order to avoid burns.

Step 7

Turn the sensors over and locate the solder points of the remaining white wires. Heat the solder and remove the pair of wires.
The sensor should be completely detachable now.

Turn the sensors over and locate the solder points of the remaining white wires. Heat the solder and remove the pair of wires.

The sensor should be completely detachable now.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Mitchell Gentry

Member since: 02/14/2018

675 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team S6-G2, Eyestone Spring 2018                        

                                                  Member of USF Tampa, Team S6-G2, Eyestone Spring 2018 



                    USFT-EYESTONE-S18S6G2                     


                                            3 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team