Difficulty

Moderate

Steps

4

Time Required

                          7 minutes            

Sections

2

  • Legs
  • 3 steps
  • Back Button Contact Point
  • 1 step

Flags

0

  • BackZoomer Meowzies

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Legs               
  • Using the Triangle driver remove the four 7.5 mm screws.
  • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

Using the Triangle driver remove the four 7.5 mm screws.

The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

1024

Step 2

  • Turn the device so that the the device is on its side.
  • Hold the back and belly on the device and gently pull apart.
  • Pulling with too much force might damage a few cables inside, so caution is needed.

Turn the device so that the the device is on its side.

Hold the back and belly on the device and gently pull apart.

Pulling with too much force might damage a few cables inside, so caution is needed.

Step 3

  • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

Step 4

              Back Button Contact Point               
  • Locate the gray rubber contact in the middle of the bottom half of the device. Using the spudger, lift one corner of the contact until it pops loose.
  • Grab the contact and gently pull until the other side detaches.
  • When replacing the contact pad, use the narrow leads on the pad to pull it into place by twisting around the tips of the tweezers.

Locate the gray rubber contact in the middle of the bottom half of the device. Using the spudger, lift one corner of the contact until it pops loose.

Grab the contact and gently pull until the other side detaches.

When replacing the contact pad, use the narrow leads on the pad to pull it into place by twisting around the tips of the tweezers.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Mitchell Gentry                     

Member since: 02/14/2018

675 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       USF Tampa, Team S6-G2, Eyestone Spring 2018                        

                                                  Member of USF Tampa, Team S6-G2, Eyestone Spring 2018 



                    USFT-EYESTONE-S18S6G2                     


                                            3 Members                     


                                            8 Guides authored