Zoomer Jurassic World Indominus Rex Eye Led Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          30 - 40 minutes

Sections

Mouth Part
2 steps
Eye LED
2 steps

Flags

BackZoomer Jurassic World Indominus Rex
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Knowing how to solder before attempting this guide is extremely encouraged. Details about soldering technique guide can be found at the last step of this guide.

What you need

Step 1

              Mouth Part

Flip the toy over to gain direct access to the first screws you need to remove for the replacement.
Remove the two (2) 7.5mm phillips screws using Phillips #1 screwdriver from the bottom of the jaw.
Remove the two (2) 7.2mm phillips screws using Phillips #0 screwdriver from the bottom of the jaw.
Gently remove the entire bottom jaw piece.

Flip the toy over to gain direct access to the first screws you need to remove for the replacement.

Remove the two (2) 7.5mm phillips screws using Phillips #1 screwdriver from the bottom of the jaw.

Remove the two (2) 7.2mm phillips screws using Phillips #0 screwdriver from the bottom of the jaw.

Gently remove the entire bottom jaw piece.

1024

Step 2

Remove the 7.5mm phillips screw using Phillips #1 screwdriver from the middle of the tongue.
Using a spudger, gently pry the tongue out of the mouth.

Remove the 7.5mm phillips screw using Phillips #1 screwdriver from the middle of the tongue.

Using a spudger, gently pry the tongue out of the mouth.

Step 3

              Eye LED

Remove the four (4) 7.5mm Phillips screws from the pieces holding the circuit board for the LEDs in place.
Use tweezers to pull the circuit board out of place.
Pull directly upward! Be careful not to break the circuit board during removal.

Remove the four (4) 7.5mm Phillips screws from the pieces holding the circuit board for the LEDs in place.

Use tweezers to pull the circuit board out of place.

Pull directly upward! Be careful not to break the circuit board during removal.

Step 4

Use a soldering iron to disconnect the four (4) wires from the circuit board.
Soldering technique guide from iFixit can be found here.
Be careful not to burn yourself or the plastic while soldering!

Use a soldering iron to disconnect the four (4) wires from the circuit board.

Soldering technique guide from iFixit can be found here.

Be careful not to burn yourself or the plastic while soldering!

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Luke Selby

Member since: 01/20/2016

624 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 10-3, Remmell Spring 2016                        

                                                  Member of USF Tampa, Team 10-3, Remmell Spring 2016 



                    USFT-REMMELL-S16S10G3                     


                                            4 Members                     


                                            7 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team