Difficulty

Moderate

Steps

6

Time Required

                          5 - 10 minutes

Sections

1

  • Nose Sensor
  • 6 steps

Flags

0

  • BackZoomer Dino Boomer

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Nose Sensor
  • Unscrew the two 7.5 mm Phillips #0 screws at the base of the neck.
  • Remove the two 7.2 mm Phillips #0 screws above these at the base of the mouth.

Unscrew the two 7.5 mm Phillips #0 screws at the base of the neck.

Remove the two 7.2 mm Phillips #0 screws above these at the base of the mouth.

1024

Step 2

  • Use the spudger to pry Zoomer Dino Boomer’s lower jaw from its mouth.

Use the spudger to pry Zoomer Dino Boomer’s lower jaw from its mouth.

Step 3

  • Remove the roof of Zoomer Dino Boomer’s mouth by unscrewing the 7.5 mm Phillips #0 screw.

Remove the roof of Zoomer Dino Boomer’s mouth by unscrewing the 7.5 mm Phillips #0 screw.

Step 4

  • Carefully push the sensors out of the nose socket with your fingers.

Carefully push the sensors out of the nose socket with your fingers.

Step 5

  • Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.
  • Use the tweezers to remove the wires as you are soldering them.
  • Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.
  • When reassembling, extra solder may be required to reconnect the wires with the circuit board.

Use a soldering iron to remove the wires from the sensor chip by melting the metal joints on the chip.

Use the tweezers to remove the wires as you are soldering them.

Do not touch any parts of Zoomer Dino Boomer or yourself when using the soldering iron. The soldering iron will be very hot.

When reassembling, extra solder may be required to reconnect the wires with the circuit board.

Step 6

  • Remove and replace the nose sensor.

Remove and replace the nose sensor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Lauren Mannix

Member since: 08/29/2015

392 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 16-1, Wollert Fall 2015                        

                                                  Member of USF Tampa, Team 16-1, Wollert Fall 2015 



                    USFT-WOLLERT-F15S16G1                     


                                            3 Members                     


                                            5 Guides authored