Difficulty
Moderate
Steps
6
Time Required
3 - 7 minutes
Sections
2
- Back Cover
- 3 steps
- Back Button
- 3 steps
Flags
0
BackZoomer Dino Boomer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Power off Zoomer Dino Boomer before disassembly.
- Remove the eight 9.3mm Phillips #1 screws.
Power off Zoomer Dino Boomer before disassembly.
Remove the eight 9.3mm Phillips #1 screws.
1024
Step 2
- Turn dinosaur over and hold upright.
- Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.
- Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.
Turn dinosaur over and hold upright.
Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.
Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.
Step 3
- Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.
- Remove back cover.
- If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.
- Do not damage the wires or circuit board.
Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.
Remove back cover.
If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.
Do not damage the wires or circuit board.
Step 4
Back Button
- Where the button is largest, squeeze the two white tabs together.
Where the button is largest, squeeze the two white tabs together.
Step 5
- Push in the white circular piece between these tabs as far as it will go.
Push in the white circular piece between these tabs as far as it will go.
Step 6
- Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose.
- Remove the back button.
Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose.
Remove the back button.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Lauren Mannix
Member since: 08/29/2015
392 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 16-1, Wollert Fall 2015
Member of USF Tampa, Team 16-1, Wollert Fall 2015
USFT-WOLLERT-F15S16G1
3 Members
5 Guides authored