Difficulty
Difficult
Steps
8
Time Required
Suggest a time??
Sections
1
- Speaker
- 8 steps
Flags
2
Better Introduction
Improve this guide by completing or revising its introduction.
Missing Details
Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.
BackZoom H1 Handy Recorder
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Speaker
- Turn the device over with its display down.
Turn the device over with its display down.
1024
Step 2
- Remove the battery cover, pressing down on the tabs and sliding.
Remove the battery cover, pressing down on the tabs and sliding.
Step 3
- Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.
Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.
Step 4
- Carefully pry up the top end of the back cover using one finger.
Carefully pry up the top end of the back cover using one finger.
Step 5
- Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.
Step 6
- De-solder the white and black speaker wires from their soldering points.
- Speaker soldering points are located on the thin section of the blue circuit board, and are marked with “SP+” and “SP-”.
- Keep in mind which color wire was connected at which terminal.
De-solder the white and black speaker wires from their soldering points.
Speaker soldering points are located on the thin section of the blue circuit board, and are marked with “SP+” and “SP-”.
Keep in mind which color wire was connected at which terminal.
Step 7
- Remove the damaged speaker from its place at the very bottom of the case, just below the battery input.
- You will have to break the glue holding the speaker in place before removing it.
Remove the damaged speaker from its place at the very bottom of the case, just below the battery input.
You will have to break the glue holding the speaker in place before removing it.
Step 8
- Replace the damaged speaker and re-solder to the original solder points.
- Ensure that the negative wire is soldered to the “SP-” while the positive wire is soldered to the “SP+” point.
Replace the damaged speaker and re-solder to the original solder points.
Ensure that the negative wire is soldered to the “SP-” while the positive wire is soldered to the “SP+” point.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Alex
Member since: 10/28/2013
809 Reputation
5 Guides authored
Badges:
7
+4 more badges