Difficulty
Moderate
Steps
8
Time Required
30 - 45 minutes
Sections
2
- Rear Case
- 3 steps
- Motherboard
- 5 steps
Flags
Missed a Step
Oops! This guide is currently missing some important steps.
Better Introduction
Improve this guide by completing or revising its introduction.
BackZeki TBQG884B
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
First, to reach the motherboard, remove the plastic backing, then the battery, and lastly the camera.
After replacing the motherboard, the device will need to be reassembled in the opposite order.
What you need
Step 1
Rear Case
- Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.
Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.
1024
Step 2
- Place the tablet down so that the screen is facing away from you.
- Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.
- Gently work your way around the perimeter of the tablet’s edge.
Place the tablet down so that the screen is facing away from you.
Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.
Gently work your way around the perimeter of the tablet’s edge.
Step 3
- Remove the back cover
- Remove any tape on the speaker and detach the speaker from the back plate.
- The speaker is connected to the motherboard by two soldered wires. Don’t break them when you remove the speaker.
Remove the back cover
Remove any tape on the speaker and detach the speaker from the back plate.
The speaker is connected to the motherboard by two soldered wires. Don’t break them when you remove the speaker.
Step 4
Motherboard
- Disconnect the Wi-Fi antenna cable from the motherboard.
Disconnect the Wi-Fi antenna cable from the motherboard.
Step 5
- Using the Phillips #1 screwdriver, remove the three screws from the motherboard..
Using the Phillips #1 screwdriver, remove the three screws from the motherboard..
Step 6
- Open the ZIF connector. Then, remove the ribbon that connects the motherboard and the screen.
Open the ZIF connector. Then, remove the ribbon that connects the motherboard and the screen.
Step 7
- Disconnect the other ZIF connector on the opposite side of the motherboard.
Disconnect the other ZIF connector on the opposite side of the motherboard.
Step 8
- Remove the motherboard and now reinsert all connectors into a new motherboard.
- In order to disconnect the battery and speaker wires from the motherboard, soldering is required. Be cautious as the soldering iron is hot.
Remove the motherboard and now reinsert all connectors into a new motherboard.
In order to disconnect the battery and speaker wires from the motherboard, soldering is required. Be cautious as the soldering iron is hot.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 12 other contributors
Linlin Cai
Member since: 09/16/2015
317 Reputation
1 Guide authored
Badges:
12
+9 more badges
Team
IUPUI, Team 1-3, Harley Fall 2015
Member of IUPUI, Team 1-3, Harley Fall 2015
IUPUI-HARLEY-F15S1G3
5 Members
5 Guides authored