Difficulty

Moderate

Steps

4

Time Required

                          30 - 45 minutes

Sections

2

  • Rear Case
  • 3 steps
  • Camera
  • 1 step

Flags

1

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

  • BackZeki TBQG884B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case
  • Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.

Remove the two screws from the end of the device where the ports are located using a Phillips #1 screwdriver.

1024

Step 2

  • Place the tablet down so that the screen is facing away from you.
  • Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.
  • Gently work your way around the perimeter of the tablet’s edge.

Place the tablet down so that the screen is facing away from you.

Insert the tip of your opening tool into the small gap between the gray and white plastic covering. Pry it open and you should hear the clips opening up.

Gently work your way around the perimeter of the tablet’s edge.

Step 3

  • Remove the back cover
  • Remove any tape on the speaker and detach the speaker from the back plate.
  • The speaker is connected to the motherboard by two soldered wires. Don’t break them when you remove the speaker.

Remove the back cover

Remove any tape on the speaker and detach the speaker from the back plate.

The speaker is connected to the motherboard by two soldered wires. Don’t break them when you remove the speaker.

Step 4

              Camera
  • Open the ZIF connector, the black locker part over the wire ribbon in the motherboard, and remove the wire ribbon that connects the motherboard and the camera.
  • The camera is located on the top left, above the motherboard.
  • The camera is usually covered with tape or material. Remove it, and peel the camera off with tweezers for safety.

Open the ZIF connector, the black locker part over the wire ribbon in the motherboard, and remove the wire ribbon that connects the motherboard and the camera.

The camera is located on the top left, above the motherboard.

The camera is usually covered with tape or material. Remove it, and peel the camera off with tweezers for safety.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 7 other contributors 


                    Natalie Holm

Member since: 09/16/2015

137 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       IUPUI, Team 1-3, Harley Fall 2015                        

                                                  Member of IUPUI, Team 1-3, Harley Fall 2015 



                    IUPUI-HARLEY-F15S1G3                     


                                            5 Members                     


                                            5 Guides authored