Difficulty
Moderate
Steps
5
Time Required
5 minutes
Sections
1
- Peel and Present System
- 5 steps
Flags
0
BackZebra ZP 505
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Peel and Present System
- Orient the printer so that the bottom is facing up.
- Remove the three P1 9mm screws located on the bottom of the printer and remove the lower unit.
Orient the printer so that the bottom is facing up.
Remove the three P1 9mm screws located on the bottom of the printer and remove the lower unit.
1024
Step 2
- Remove the P0 9mm screw.
- Proceed to remove the cover.
Remove the P0 9mm screw.
Proceed to remove the cover.
Step 3
- Disconnect the harness.
- Thread the harness through the hole on the right hand side.
Disconnect the harness.
Thread the harness through the hole on the right hand side.
Step 4
- Remove the peel and present system by utilizing a metal spudger.
Remove the peel and present system by utilizing a metal spudger.
Step 5
- Remove the peel and present system.
Remove the peel and present system.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Brian Jagger
Member since: 09/27/2017
316 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S8-G2, Banghart Fall 2017
Member of Cal Poly, Team S8-G2, Banghart Fall 2017
CPSU-BANGHART-F17S8G2
4 Members
5 Guides authored