Difficulty
Moderate
Steps
4
Time Required
5 minutes
Sections
1
- Latch Hook
- 4 steps
Flags
0
BackZebra ZP 505
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Latch Hook
- Remove the following screws securing the top cover of the ZP 505.
- Six P1 9.0mm
- One P0 19.0mm
Remove the following screws securing the top cover of the ZP 505.
Six P1 9.0mm
One P0 19.0mm
1024
Step 2
- Close the printer.
- Carefully remove the top cover and set it to the side.
Close the printer.
Carefully remove the top cover and set it to the side.
Step 3
- Locate the green wire on the front, left side of the printer and remove it.
Locate the green wire on the front, left side of the printer and remove it.
Step 4
- Pry out the tabs, making sure to hold the springs in place.
- Once the tabs are out, remove the latch hook.
Pry out the tabs, making sure to hold the springs in place.
Once the tabs are out, remove the latch hook.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Sarah Raykhman
Member since: 09/27/2017
201 Reputation
2 Guides authored
Badges:
3
Team
Cal Poly, Team S8-G2, Banghart Fall 2017
Member of Cal Poly, Team S8-G2, Banghart Fall 2017
CPSU-BANGHART-F17S8G2
4 Members
5 Guides authored