Zebra Zp 450 Power Switch Replacement Repair Guide

Difficulty

Difficult

Steps

5

Time Required

                          30 - 35 minutes            

Sections

2

• Motherboard
• 4 steps
• Power Switch
• 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackZebra ZP 450

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

In order to complete this guide, you’ll need to know how to solder. Please visit the How to Solder and Desolder Connections guide for more information on proper soldering technique.

What you need

Step 1

              Motherboard               

• Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.
• Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.

Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.

Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.

1024

Step 2

• Remove the single 7mm screw located underneath the outfeed using the same Phillips #1 screwdriver.

Remove the single 7mm screw located underneath the outfeed using the same Phillips #1 screwdriver.

Step 3

• Using an opening pick, pry the plastic covering from around the power button and accessory ports.

Using an opening pick, pry the plastic covering from around the power button and accessory ports.

Step 4

• After lifting the plastic casing from the device, use the Phillips #1 screwdriver to remove the single 5mm screw securing the motherboard.
• Remove all connections to the motherboard.

After lifting the plastic casing from the device, use the Phillips #1 screwdriver to remove the single 5mm screw securing the motherboard.

Remove all connections to the motherboard.

Step 5

              Power Switch               

• Using the soldering iron, unsolder the joints on the back of the motherboard connecting the power switch to the motherboard.
• For more information on proper soldering technique, please visit the How to Solder and Desolder Connections guide.

Using the soldering iron, unsolder the joints on the back of the motherboard connecting the power switch to the motherboard.

For more information on proper soldering technique, please visit the How to Solder and Desolder Connections guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Daniel Garmon                     

Member since: 02/15/2021

277 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       The Citadel Military College of South Carolina, Team S1-G6, Eggleston Spring 2021                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G6, Eggleston Spring 2021 



                    CMCSC-EGGLESTON-S21S1G6                     


                                            2 Members                     


                                            3 Guides authored