Difficulty
Easy
Steps
3
Time Required
5 minutes
Sections
1
- Power Cord
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackZebra ZP 450
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.
- Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.
Using the TR10 Torx screwdriver, remove the four 8mm screws from the bottom of the device.
Remove the three 12mm screws from the bottom of the printer using a Phillips #1 screwdriver.
1024
Step 2
- Using the iFixit opening pick, remove the plastic cover.
Using the iFixit opening pick, remove the plastic cover.
Step 3
- Using the Phillips #1 screwdriver, remove the single 14 mm screw from the clamp that is holding the power cord.
- Remove the power cord from the device.
Using the Phillips #1 screwdriver, remove the single 14 mm screw from the clamp that is holding the power cord.
Remove the power cord from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Daniel Garmon
Member since: 02/15/2021
277 Reputation
3 Guides authored
Badges:
4
+1 more badge
Team
The Citadel Military College of South Carolina, Team S1-G6, Eggleston Spring 2021
Member of The Citadel Military College of South Carolina, Team S1-G6, Eggleston Spring 2021
CMCSC-EGGLESTON-S21S1G6
2 Members
3 Guides authored