Difficulty
Moderate
Steps
5
Time Required
15 - 20 minutes
Sections
1
- Feed Key
- 5 steps
Flags
0
BackZebra ZP 450
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Open Lid and Unscrew Screws
- This device uses electricity, so it is best to unplug it before going any farther.
- Remove 5 11.08mm Phillips screws that will come out of the casing once loose.
- There is one Phillips screw at the bottom center set deep inside the casing - it is easy to get to with a thin screwdriver. This screw will come loose, but stay inside the casing. Don’t be surprised when it won’t drop out.
This device uses electricity, so it is best to unplug it before going any farther.
Remove 5 11.08mm Phillips screws that will come out of the casing once loose.
There is one Phillips screw at the bottom center set deep inside the casing - it is easy to get to with a thin screwdriver. This screw will come loose, but stay inside the casing. Don’t be surprised when it won’t drop out.
1024
Step 2
Remove Top
- Position your hands one on either side of the top.
- Put your thumbs on the front and your 4 fingers on the sides.
- Push outwards with your 4 fingers to remove the plastic top.
- Wiggling the top may help loosen it from the bottom screw that is still in the case.
Position your hands one on either side of the top.
Put your thumbs on the front and your 4 fingers on the sides.
Push outwards with your 4 fingers to remove the plastic top.
Wiggling the top may help loosen it from the bottom screw that is still in the case.
Step 3
Open Lid
- Put the lid back down and lay the top open as shown in the photo.
- Be careful setting the lid down, as it could pull wiring from other components. If you need more wiggle room, you can remove the silver cable from the support clip on the side, as seen in the second photo by pulling the tab back and pushing the cable up.
- The component we are replacing is on the underneath of the top of the device, highlighted in the photo
Put the lid back down and lay the top open as shown in the photo.
Be careful setting the lid down, as it could pull wiring from other components. If you need more wiggle room, you can remove the silver cable from the support clip on the side, as seen in the second photo by pulling the tab back and pushing the cable up.
The component we are replacing is on the underneath of the top of the device, highlighted in the photo
Step 4
Remove No-Fuss Ribbon Cable Connectors
- Starting with either ribbon cable, grip it on either side and gently pull out - The cable will come out of it’s connector.
- Repeat for other ribbon cable
- Ribbons may be fragile, so handle with care.
Starting with either ribbon cable, grip it on either side and gently pull out - The cable will come out of it’s connector.
Repeat for other ribbon cable
Ribbons may be fragile, so handle with care.
Step 5
Remove Circuit Board
- Remove 2 7.51mm Phillips screws holding the circuit board onto the device casing.
Remove 2 7.51mm Phillips screws holding the circuit board onto the device casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Keeland Roche
Member since: 10/11/2014
158 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
USF Tampa, Team 1-28, Donnelly Fall 2014
Member of USF Tampa, Team 1-28, Donnelly Fall 2014
USFT-DONNELLY-F14S1G28
1 Member
1 Guide authored