Difficulty

Moderate

Steps

9

Time Required

                          10 - 15 minutes

Sections

5

  • Back Panel
  • 2 steps
  • Battery
  • 3 steps
  • Rumble Motor
  • 1 step
  • Motherboard
  • 2 steps
  • Left Joystick
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackZD-N Plus Wireless Controller

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Remove the seven 12mm JIS #00 screws that hold the back panel in place.

Remove the seven 12mm JIS #00 screws that hold the back panel in place.

1024

Step 2

  • Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.

Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.

Step 3

              Battery
  • Use an opening tool to pry the battery from its original position.
  • The battery is glued on, so this may take some effort.

Use an opening tool to pry the battery from its original position.

The battery is glued on, so this may take some effort.

Step 4

  • Use an opening tool to pry the connector away from the two metallic prongs.
  • The parts are built to stay together, so this may take some effort.
  • Be careful to not warp the prongs in the process.

Use an opening tool to pry the connector away from the two metallic prongs.

The parts are built to stay together, so this may take some effort.

Be careful to not warp the prongs in the process.

Step 5

  • Remove the battery from the controller.

Remove the battery from the controller.

Step 6

              Rumble Motor
  • Remove the electrical connector attaching each rumble motor to the controller.
  • Lift up on the circular section of the rumble to remove it from the controller.

Remove the electrical connector attaching each rumble motor to the controller.

Lift up on the circular section of the rumble to remove it from the controller.

Step 7

              Motherboard
  • Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.

Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.

Step 8

  • Lift the motherboard out of the controller.

Lift the motherboard out of the controller.

Step 9

              Left Joystick
  • Pull up on the left joystick to remove it from the motherboard. The plastic piece will unclip easily.

Pull up on the left joystick to remove it from the motherboard. The plastic piece will unclip easily.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Stacie Schmidt

Member since: 10/15/2019

415 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Grand Valley State University, Team S4-G1, DeVasto Fall 2019                        

                                                  Member of Grand Valley State University, Team S4-G1, DeVasto Fall 2019 



                    GVSU-DEVASTO-F19S4G1                     


                                            4 Members                     


                                            7 Guides authored