Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
2
- Back Panel
- 2 steps
- Battery
- 3 steps
Flags
1
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackZD-N Plus Wireless Controller
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Remove the seven 12mm JIS #00 screws that hold the back panel in place.
Remove the seven 12mm JIS #00 screws that hold the back panel in place.
1024
Step 2
- Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
Step 3
Battery
- Use an opening tool to pry the battery from its original position.
- The battery is glued on, so this may take some effort.
Use an opening tool to pry the battery from its original position.
The battery is glued on, so this may take some effort.
Step 4
- Use an opening tool to pry the connector away from the two metallic prongs.
- The parts are built to stay together, so this may take some effort.
- Be careful to not warp the prongs in the process.
Use an opening tool to pry the connector away from the two metallic prongs.
The parts are built to stay together, so this may take some effort.
Be careful to not warp the prongs in the process.
Step 5
- Remove the battery from the controller.
Remove the battery from the controller.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Devin Matos
Member since: 10/15/2019
175 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
Grand Valley State University, Team S4-G1, DeVasto Fall 2019
Member of Grand Valley State University, Team S4-G1, DeVasto Fall 2019
GVSU-DEVASTO-F19S4G1
4 Members
7 Guides authored