Difficulty
Moderate
Steps
4
Time Required
6 minutes
Sections
1
- LED Board
- 4 steps
Flags
0
BackYuneec Typhoon H
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LED Board
- This guide begins with the propeller already removed.
This guide begins with the propeller already removed.
1024
Step 2
- Turn the drone upside down to have easy access to the prop arm.
- Twist out the prop motor clockwise.
Turn the drone upside down to have easy access to the prop arm.
Twist out the prop motor clockwise.
Step 3
- Unscrew two 4.9mm screws on the board using a Phillips #000 screwdriver.
Unscrew two 4.9mm screws on the board using a Phillips #000 screwdriver.
Step 4
- Hold the LED board in one hand and pinch the plug at the connection to the board with the other hand.
- Pull the plug out from the connection piece.
Hold the LED board in one hand and pinch the plug at the connection to the board with the other hand.
Pull the plug out from the connection piece.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Claire Luce
Member since: 04/16/2018
371 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S22-G3, Maness Spring 2018
Member of Cal Poly, Team S22-G3, Maness Spring 2018
CPSU-MANESS-S18S22G3
4 Members
5 Guides authored