Difficulty

Moderate

Steps

10

Time Required

                          5 minutes

Sections

2

  • Battery
  • 3 steps
  • Joystick Removal
  • 7 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackYuneec ST10 Plus

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the controller upside down to access the battery compartment.
  • Grab the compartment door and pull down.

Flip the controller upside down to access the battery compartment.

Grab the compartment door and pull down.

1024

Step 2

  • Gently lift the blue tab connected to the battery in order to remove the battery from its housing.

Gently lift the blue tab connected to the battery in order to remove the battery from its housing.

Step 3

  • To disconnect the battery from the remote, grab the red and black connectors.
  • Pull gently on connectors until they disconnect.

To disconnect the battery from the remote, grab the red and black connectors.

Pull gently on connectors until they disconnect.

Step 4

              Joystick Removal
  • Slide the Jimmy underneath the rubber grips and pry upwards.
  • With your free hand grasp the rubber grips and pull upward to remove it.

Slide the Jimmy underneath the rubber grips and pry upwards.

With your free hand grasp the rubber grips and pull upward to remove it.

Step 5

  • Remove the six 1.3 cm screws located on the back panel of the remote using the 5.5mm hex screw bit.

Remove the six 1.3 cm screws located on the back panel of the remote using the 5.5mm hex screw bit.

Step 6

  • Remove the four 6mm screws from the handle using the 4mm hex driver bit.

Remove the four 6mm screws from the handle using the 4mm hex driver bit.

Step 7

  • Carefully pull up and over on the back panel to remove. Take your time because there are wires connecting the two panels that can be easily torn.

Carefully pull up and over on the back panel to remove. Take your time because there are wires connecting the two panels that can be easily torn.

Step 8

  • Use the nylon tipped tweezers to pull the two joystick cables from their connectors.
  • The cable connectors are located in the middle of the device and are inline with the two joysticks on the motherboard.

Use the nylon tipped tweezers to pull the two joystick cables from their connectors.

The cable connectors are located in the middle of the device and are inline with the two joysticks on the motherboard.

Step 9

  • With the 5mm hex diver bit, remove the eight 10mm screws surrounding both joysticks.

With the 5mm hex diver bit, remove the eight 10mm screws surrounding both joysticks.

Step 10

  • Flip the controller back over.
  • Remove the joysticks.

Flip the controller back over.

Remove the joysticks.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Joshua Collins

Member since: 01/27/2020

577 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Embry-Riddle Aeronautical University, Team S6-G6, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S6-G6, Watkins Spring 2020 



                    ERAU-WATKINS-S20S6G6                     


                                            5 Members                     


                                            5 Guides authored