Yujin Robot Iclebo Arte Main Brush Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 minutes

Sections

Dust Bin
2 steps
Main Brush
3 steps

Flags

BackYujin iCLEBO Arte YCR-M05
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Dust Bin

Remove the dust bin by gently pressing the silver button on top of the vacuum until the bin releases.

Remove the dust bin by gently pressing the silver button on top of the vacuum until the bin releases.

1024

Step 2

Grip the bottom of the dust bin. Push up on the tabs as indicated by the yellow arrows.
Empty contents of bin into waste receptacle and rinse with water as needed.

Grip the bottom of the dust bin. Push up on the tabs as indicated by the yellow arrows.

Empty contents of bin into waste receptacle and rinse with water as needed.

Step 3

              Main Brush

Flip over the device to access the brush cover.
To remove the brush cover, push together the two snap releases on the right and left sides of the cover until it releases.
Do not push the release snaps too close together. Doing so may cause them to break and the brush could fall out when in use.

Flip over the device to access the brush cover.

To remove the brush cover, push together the two snap releases on the right and left sides of the cover until it releases.

Do not push the release snaps too close together. Doing so may cause them to break and the brush could fall out when in use.

Step 4

Grip the left side of the brush with the square end-piece and pull up until the brush pops out.

Grip the left side of the brush with the square end-piece and pull up until the brush pops out.

Step 5

When preparing a new brush, it is very important to make sure that the new one is equipped with the proper end-pieces.
Take the round metal piece and slide it into the square rubber coating. Then, stick it on the end with the metal peg.

When preparing a new brush, it is very important to make sure that the new one is equipped with the proper end-pieces.

Take the round metal piece and slide it into the square rubber coating. Then, stick it on the end with the metal peg.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Trent Treiber

Member since: 02/28/2017

204 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team S2-G3, Nance Spring 2017                        

                                                  Member of USF Tampa, Team S2-G3, Nance Spring 2017 



                    USFT-NANCE-S17S2G3                     


                                            4 Members                     


                                            14 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team