Difficulty
Very easy
Steps
4
Time Required
5 minutes
Sections
1
- Battery
- 4 steps
Flags
0
BackYujin iCLEBO Arte YCR-M05
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Locate and unscrew the two 15mm screws with a Phillips #2 screwdriver.
Locate and unscrew the two 15mm screws with a Phillips #2 screwdriver.
1024
Step 2
- Remove both screws shown by rotating them counter-clockwise.
Remove both screws shown by rotating them counter-clockwise.
Step 3
- Remove the battery compartment’s lid.
Remove the battery compartment’s lid.
Step 4
- Slide the battery out, and disconnect it from the robot by squeezing the tab on the power cable.
- If you pull too hard on the connector without properly squeezing the tab, something will break.
Slide the battery out, and disconnect it from the robot by squeezing the tab on the power cable.
If you pull too hard on the connector without properly squeezing the tab, something will break.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Trent Bingel
Member since: 02/28/2017
428 Reputation
4 Guides authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S2-G3, Nance Spring 2017
Member of USF Tampa, Team S2-G3, Nance Spring 2017
USFT-NANCE-S17S2G3
4 Members
14 Guides authored
desrn55 - Feb 28, 2021
Reply
Tried 2 different new batteries and still won’t charge