Difficulty

Moderate

Steps

9

Time Required

                          20 minutes

Sections

3

  • Rear Casing
  • 4 steps
  • Wiring
  • 4 steps
  • Front Panel and Speaker Housing
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackYamaha NS-AW190BL

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rear Casing
  • Remove the six Phillips Head 1.2mm screws on the front side of the speaker.

Remove the six Phillips Head 1.2mm screws on the front side of the speaker.

1024

Step 2

  • Crack open both parts of the casing carefully.
  • Using a plastic opening tool, wedge open the bottom of the speaker to separate the two parts of the speaker.

Crack open both parts of the casing carefully.

Using a plastic opening tool, wedge open the bottom of the speaker to separate the two parts of the speaker.

Step 3

  • Remove the cooling foam.
  • Use a metal spudger to push the tab in on the red wire.
  • Repeat the process for the blue wire.

Remove the cooling foam.

Use a metal spudger to push the tab in on the red wire.

Repeat the process for the blue wire.

Step 4

  • The blue wire can now be removed from its connector.
  • Remove the red wire to free the rear casing.

The blue wire can now be removed from its connector.

Remove the red wire to free the rear casing.

Step 5

              Wiring
  • Use the metal spudger to bend down the metal tabs that hold the wires to the terminals. The tabs are small and in between the grooves of the terminal.

Use the metal spudger to bend down the metal tabs that hold the wires to the terminals. The tabs are small and in between the grooves of the terminal.

Step 6

  • Remove the wires from the terminals.

Remove the wires from the terminals.

Step 7

  • Use the metal spudger to bend the metal tabs that hold the connectors to the terminals.

Use the metal spudger to bend the metal tabs that hold the connectors to the terminals.

Step 8

  • Remove the wires from the terminals. Then remove the entire wire assembly.

Remove the wires from the terminals. Then remove the entire wire assembly.

Step 9

              Front Panel and Speaker Housing
  • Once the wire assembly is removed, the entire front panel and speaker housing should be separated to replace.

Once the wire assembly is removed, the entire front panel and speaker housing should be separated to replace.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Nick Ruiz

Member since: 02/07/2017

331 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 17-3, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 17-3, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S17G3                     


                                            4 Members                     


                                            5 Guides authored