Xps M2010 Mxp061 Cosmetic Cover And Top Cover Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          3 - 7 minutes            

Sections

1

• Cosmetic Cover and Top Cover
• 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackDell XPS M2010 MXP061

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The information and pictures in this guide have been taken from the service manual from this device, listed on the iFixit product page. If you need any additional information on disassembling this device, please consult the service manual.

What you need

Step 1

              Removing the Cosmetic Cover               

• After turning off the computer and opening the display, remove the keyboard from the computer.
• With a flat-head screwdriver, press in the cover-release slot (#3) on the side of the computer.
• While holding the screwdriver in (so that the button inside the slot is still being held), lift up the cosmetic cover (#2) by the cosmetic-cover notch (#1).

After turning off the computer and opening the display, remove the keyboard from the computer.

With a flat-head screwdriver, press in the cover-release slot (#3) on the side of the computer.

While holding the screwdriver in (so that the button inside the slot is still being held), lift up the cosmetic cover (#2) by the cosmetic-cover notch (#1).

1024

Step 2

              Removing the Top Cover: Screws               

• Unscrew the six M2.5 x 5-mm screws on the left side (#1) of the top cover, then unscrew the seven M2.5 x 5-mm screws on the right side (#2) of the top cover.

Unscrew the six M2.5 x 5-mm screws on the left side (#1) of the top cover, then unscrew the seven M2.5 x 5-mm screws on the right side (#2) of the top cover.

Step 3

              Removing the Top Cover: Cables               

• Slightly lift up the top cover, but do not fully remove it. Two cables are connected to the top cover, and they could be damaged if the top cover is improperly removed.
• While holding the top cover up, unplug the two cable connectors by pulling up on the pull loop or connector.

Slightly lift up the top cover, but do not fully remove it. Two cables are connected to the top cover, and they could be damaged if the top cover is improperly removed.

While holding the top cover up, unplug the two cable connectors by pulling up on the pull loop or connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    William Daniels                     

Member since: 04/06/2018

820 Reputation

                                      6 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges