Difficulty

Moderate

Steps

6

Time Required

                          30 minutes

Sections

3

  • Battery
  • 3 steps
  • Midframe
  • 2 steps
  • Rear Camera
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackXiaomi Redmi Note

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Make sure the Xiaomi Redmi Note is powered off before removing the battery.
  • Insert the plastic opening tool between the charging port and the rear case.
  • Pry the end of the rear case up from the charging port.

Make sure the Xiaomi Redmi Note is powered off before removing the battery.

Insert the plastic opening tool between the charging port and the rear case.

Pry the end of the rear case up from the charging port.

1024

Step 2

  • Run the plastic opening tool along the seam on the side of the phone to remove the rear casing.

Run the plastic opening tool along the seam on the side of the phone to remove the rear casing.

Step 3

  • Locate the indentation at the bottom of the battery.
  • Place a finger in the indentation and lift up to remove the battery.

Locate the indentation at the bottom of the battery.

Place a finger in the indentation and lift up to remove the battery.

Step 4

              Midframe
  • Remove twelve 3.5mm Phillips #00 screws from the midframe.

Remove twelve 3.5mm Phillips #00 screws from the midframe.

Step 5

  • Insert a plastic opening into the seam between the midframe and the bottom frame of the phone.
  • Run the plastic opening tool along the seam.
  • Pry up the midframe with the plastic opening tool.
  • Once the midframe has been sufficiently lifted with the tool, place a hand underneath the edge to lift the entire component out of the frame.
  • There will be snapping sounds as the clips on the midframe disconnect from the phone.

Insert a plastic opening into the seam between the midframe and the bottom frame of the phone.

Run the plastic opening tool along the seam.

Pry up the midframe with the plastic opening tool.

Once the midframe has been sufficiently lifted with the tool, place a hand underneath the edge to lift the entire component out of the frame.

There will be snapping sounds as the clips on the midframe disconnect from the phone.

Step 6

              Rear Camera
  • Disconnect the rear-facing camera from the motherboard by pulling out the press-fit connector to its left.

Disconnect the rear-facing camera from the motherboard by pulling out the press-fit connector to its left.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 3 other contributors 


                    AJ Beers

Member since: 04/26/2017

213 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S22-G4, Livingston Spring 2017                        

                                                  Member of Cal Poly, Team S22-G4, Livingston Spring 2017 



                    CPSU-LIVINGSTON-S17S22G4                     


                                            4 Members                     


                                            16 Guides authored