Xiaomi Redmi Note Front Facing Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          25 minutes

Sections

Battery
3 steps
Midframe
2 steps
Front-Facing Camera
1 step

Flags

BackXiaomi Redmi Note
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Make sure the Xiaomi Redmi Note is powered off before removing the battery.
Insert the plastic opening tool between the charging port and the rear case.
Pry the end of the rear case up from the charging port.

Make sure the Xiaomi Redmi Note is powered off before removing the battery.

Insert the plastic opening tool between the charging port and the rear case.

Pry the end of the rear case up from the charging port.

1024

Step 2

Run the plastic opening tool along the seam on the side of the phone to remove the rear casing.

Run the plastic opening tool along the seam on the side of the phone to remove the rear casing.

Step 3

Locate the indentation at the bottom of the battery.
Place a finger in the indentation and lift up to remove the battery.

Locate the indentation at the bottom of the battery.

Place a finger in the indentation and lift up to remove the battery.

Step 4

              Midframe

Remove twelve 3.5mm Phillips #00 screws from the midframe.

Remove twelve 3.5mm Phillips #00 screws from the midframe.

Step 5

Insert a plastic opening into the seam between the midframe and the bottom frame of the phone.
Run the plastic opening tool along the seam.
Pry up the midframe with the plastic opening tool.
Once the midframe has been sufficiently lifted with the tool, place a hand underneath the edge to lift the entire component out of the frame.
There will be snapping sounds as the clips on the midframe disconnect from the phone.

Insert a plastic opening into the seam between the midframe and the bottom frame of the phone.

Run the plastic opening tool along the seam.

Pry up the midframe with the plastic opening tool.

Once the midframe has been sufficiently lifted with the tool, place a hand underneath the edge to lift the entire component out of the frame.

There will be snapping sounds as the clips on the midframe disconnect from the phone.

Step 6

              Front-Facing Camera

Use tweezers to lift the retaining flap of the zero insertion force (ZIF) connector to the upright position.
Use tweezers to pull the ribbon cable out of the ZIF connector.
Remove the front-facing camera from the motherboard.

Use tweezers to lift the retaining flap of the zero insertion force (ZIF) connector to the upright position.

Use tweezers to pull the ribbon cable out of the ZIF connector.

Remove the front-facing camera from the motherboard.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Caitlin Settles

Member since: 04/26/2017

702 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team S22-G4, Livingston Spring 2017                        

                                                  Member of Cal Poly, Team S22-G4, Livingston Spring 2017 



                    CPSU-LIVINGSTON-S17S22G4                     


                                            4 Members                     


                                            16 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team