Difficulty
Moderate
Steps
6
Time Required
10 - 15 minutes
Sections
1
- Upper Plastic Case
- 6 steps
Flags
0
BackXbox One X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Turn off the console and unplug any cables before beginning this guide.
What you need
Step 1
Remove the sticker
- Use blunt tweezers to peel off the sticker covering the right-side screw on the back of the console.
- Before starting this guide: Turn off the device. Then, unplug any cables from the console.
Use blunt tweezers to peel off the sticker covering the right-side screw on the back of the console.
Before starting this guide: Turn off the device. Then, unplug any cables from the console.
1024
Step 2
Remove the external screws
- Use a T10 Torx screwdriver to remove the two 12.6 mm–long screws located on the back of the console.
Use a T10 Torx screwdriver to remove the two 12.6 mm–long screws located on the back of the console.
Step 3
Slide the upper case horizontally
- Rotate the console 90 degrees.
- Pull the front of the upper plastic case horizontally toward the front of the console until it comes to a stop. This slides the clips out of the slots on the upper plastic case.
Rotate the console 90 degrees.
Pull the front of the upper plastic case horizontally toward the front of the console until it comes to a stop. This slides the clips out of the slots on the upper plastic case.
Step 4
Lift the upper case off the lower case
- Rotate the console 90 degrees so that the back is facing you.
- Lift up the left side of the upper plastic case (as viewed from the back of the console), stopping when it won’t lift any further.
Rotate the console 90 degrees so that the back is facing you.
Lift up the left side of the upper plastic case (as viewed from the back of the console), stopping when it won’t lift any further.
Step 5
- While continuing to hold the left side of the upper plastic case, push up on the right side to move the right-side screw boss out of the way.
- If pushing up on the case doesn’t work, try moving it in different directions until it can swing open.
- Swing the upper plastic case open to 75 degrees.
While continuing to hold the left side of the upper plastic case, push up on the right side to move the right-side screw boss out of the way.
If pushing up on the case doesn’t work, try moving it in different directions until it can swing open.
Swing the upper plastic case open to 75 degrees.
Step 6
- Push the upper plastic case down and away from the console to remove it completely.
Push the upper plastic case down and away from the console to remove it completely.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 2 other contributors
Kyle Smith
Member since: 02/01/2021
34,298 Reputation
123 Guides authored
Badges:
32
+29 more badges