Xbox One S All Digital Edition Top Metal Shield Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          15 minutes            

Sections

2

• Plastic Enclosure
• 4 steps
• Top Metal Shield
• 2 steps

Flags

0

• BackXbox One S All Digital Edition

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This step shows how to carefully separate the top metal casing from the bottom. If there are noises from the fan, the metal casing could be the problem, prohibiting fan movement. Disconnect all cables prior to disassembly.

What you need

Step 1

              Plastic Enclosure               

• Position the iFixit Opening Tool’s riveted edge in between the top and bottom cover of the plastic enclosure.
• Apply downward pressure on the iFixit Opening Tool until the security clip unlocks.
• Repeat on different points of the plastic enclosure until the bottom cover is removed.

Position the iFixit Opening Tool’s riveted edge in between the top and bottom cover of the plastic enclosure.

Apply downward pressure on the iFixit Opening Tool until the security clip unlocks.

Repeat on different points of the plastic enclosure until the bottom cover is removed.

1024

Step 2

• Remove the six 50 mm green screws (labeled F1-F6) from the metal chassis using a Torx 10 screwdriver.
• These screws hold the top cover of the plastic enclosure to the chassis.

Remove the six 50 mm green screws (labeled F1-F6) from the metal chassis using a Torx 10 screwdriver.

These screws hold the top cover of the plastic enclosure to the chassis.

Step 3

• Apply pressure to peel off the sides of the casing.
• Separate the metal chassis from the top cover, lifting the back of the chassis up and away from the top cover.
• The plastic back panel is meant to stay attached to the metal chassis.

Apply pressure to peel off the sides of the casing.

Separate the metal chassis from the top cover, lifting the back of the chassis up and away from the top cover.

The plastic back panel is meant to stay attached to the metal chassis.

Step 4

• Flip the metal enclosure so that the fan cover is on top.

Flip the metal enclosure so that the fan cover is on top.

Step 5

              Top Metal Shield               

• Remove the two 15mm screws from the front panel using the Torx T8 screwdriver.

Remove the two 15mm screws from the front panel using the Torx T8 screwdriver.

Step 6

• Carefully slide the top metal case off the frame.
• This may require shifting the case side to side as you slide up.

Carefully slide the top metal case off the frame.

This may require shifting the case side to side as you slide up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Jules Hajjar                     

Member since: 10/10/2019

1,372 Reputation

                                      8 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges                           

Team

                       Cal Poly, Team S12-G6, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S12-G6, Regan Fall 2019 



                    CPSU-REGAN-F19S12G6                     


                                            4 Members                     


                                            24 Guides authored