Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

2

  • Plastic Enclosure
  • 4 steps
  • IR Blaster
  • 2 steps

Flags

0

  • BackXbox One S All Digital Edition

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Plastic Enclosure
  • Position the iFixit Opening Tool’s riveted edge in between the top and bottom cover of the plastic enclosure.
  • Apply downward pressure on the iFixit Opening Tool until the security clip unlocks.
  • Repeat on different points of the plastic enclosure until the bottom cover is removed.

Position the iFixit Opening Tool’s riveted edge in between the top and bottom cover of the plastic enclosure.

Apply downward pressure on the iFixit Opening Tool until the security clip unlocks.

Repeat on different points of the plastic enclosure until the bottom cover is removed.

1024

Step 2

  • Remove the six 50 mm green screws (labeled F1-F6) from the metal chassis using a Torx 10 screwdriver.
  • These screws hold the top cover of the plastic enclosure to the chassis.

Remove the six 50 mm green screws (labeled F1-F6) from the metal chassis using a Torx 10 screwdriver.

These screws hold the top cover of the plastic enclosure to the chassis.

Step 3

  • Apply pressure to peel off the sides of the casing.
  • Separate the metal chassis from the top cover, lifting the back of the chassis up and away from the top cover.
  • The plastic back panel is meant to stay attached to the metal chassis.

Apply pressure to peel off the sides of the casing.

Separate the metal chassis from the top cover, lifting the back of the chassis up and away from the top cover.

The plastic back panel is meant to stay attached to the metal chassis.

Step 4

  • Flip the metal enclosure so that the fan cover is on top.

Flip the metal enclosure so that the fan cover is on top.

Step 5

              IR Blaster
  • Remove the four 15mm screws attaching the IR Blaster to the metal chassis with the Torx T8 Security screwdriver.

Remove the four 15mm screws attaching the IR Blaster to the metal chassis with the Torx T8 Security screwdriver.

Step 6

  • Carefully remove the IR Blaster from the metal chassis.
  • The connector is very fragile. Make sure you pull the board away from the case and not sideways.

Carefully remove the IR Blaster from the metal chassis.

The connector is very fragile. Make sure you pull the board away from the case and not sideways.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Jules Hajjar

Member since: 10/10/2019

1,372 Reputation

                                      8 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       Cal Poly, Team S12-G6, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S12-G6, Regan Fall 2019 



                    CPSU-REGAN-F19S12G6                     


                                            4 Members                     


                                            24 Guides authored