Difficulty
Moderate
Steps
5
Time Required
30 minutes
Sections
2
- RF Module
- 2 steps
- Xbox 360 S RF Board Repair
- 3 steps
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackXbox 360 S
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
RF Module
- Remove the two 5.6 mm T8 Torx screws securing the RF module to the metal case.
Remove the two 5.6 mm T8 Torx screws securing the RF module to the metal case.
1024
Step 2
- The RF module is still connected to the Xbox by a large USB-type connector.
- Pull the board directly away from the Xbox to remove it.
The RF module is still connected to the Xbox by a large USB-type connector.
Pull the board directly away from the Xbox to remove it.
Step 3
PSU Check
- First things first, check the power supply. When plugged into the wall but not plugged into the unit, it should emit an orange light (showing that it is in standby mode). This light should stay orange when plugged into the unit. If it turns red, you likely have a PSU fault.
First things first, check the power supply. When plugged into the wall but not plugged into the unit, it should emit an orange light (showing that it is in standby mode). This light should stay orange when plugged into the unit. If it turns red, you likely have a PSU fault.
Step 4
Faceplate Check
- To access the RF board, follow the RF module replacement guide for the unit, linked here.
- First try disconnecting and reconnecting the ribbon cable for the faceplate. If this doesn’t affect the issue, continue with the guide.
To access the RF board, follow the RF module replacement guide for the unit, linked here.
First try disconnecting and reconnecting the ribbon cable for the faceplate. If this doesn’t affect the issue, continue with the guide.
Step 5
RF Board Repair
- The safest solution is to purchase a new RF Board, but there is a more immediate solution available
- Capacitor C57 on the RF Board frequently shorts out causing the entire board to fail, but it is not strictly necessary for the board to function. You can either desolder the capacitor or pop it off with a screwdriver. Just be careful not to damage any other capacitors
- Note: the buttons on the board still may not work, the console may occasionally make eject or power sounds, but it will function with a wireless controller and turn on/off accordingly.
- EMBEDONIX has a video more carefully describing this process, linked here.
The safest solution is to purchase a new RF Board, but there is a more immediate solution available
Capacitor C57 on the RF Board frequently shorts out causing the entire board to fail, but it is not strictly necessary for the board to function. You can either desolder the capacitor or pop it off with a screwdriver. Just be careful not to damage any other capacitors
Note: the buttons on the board still may not work, the console may occasionally make eject or power sounds, but it will function with a wireless controller and turn on/off accordingly.
EMBEDONIX has a video more carefully describing this process, linked here.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Bayden Yazalina
Member since: 06/29/2019
123 Reputation
1 Guide authored
Badges:
4
+1 more badge