Difficulty
Moderate
Steps
6
Time Required
10 minutes
Sections
1
- Front Panel
- 6 steps
Flags
0
BackXbox 360 E
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Panel
- In front of the CD drive you will find the Xbox logo. Press on the area left of the Xbox logo, and the disk tray panel will pop off.
In front of the CD drive you will find the Xbox logo. Press on the area left of the Xbox logo, and the disk tray panel will pop off.
1024
Step 2
- Beginning on the left side without the grate, run the spudger along the crevice until you’ve reached the grated part, while holding the part that’s being separated as you go.
Beginning on the left side without the grate, run the spudger along the crevice until you’ve reached the grated part, while holding the part that’s being separated as you go.
Step 3
- Keep holding the partially separated panel open. It’s easiest to do this by wedging a spudger into the opening but can also be held open by your hands.
- Rotate the Xbox to the left to locate the clip connecting the front panel to the body. Insert the spudger inside the gap to release the clip. This may require wiggling the spudger. The clip will pop off, making the front panel looser.
Keep holding the partially separated panel open. It’s easiest to do this by wedging a spudger into the opening but can also be held open by your hands.
Rotate the Xbox to the left to locate the clip connecting the front panel to the body. Insert the spudger inside the gap to release the clip. This may require wiggling the spudger. The clip will pop off, making the front panel looser.
Step 4
- Flip the Xbox so the opposite side is towards you. Make sure to keep the separation open.
- Locate the other clip and insert the spudger to remove it.
Flip the Xbox so the opposite side is towards you. Make sure to keep the separation open.
Locate the other clip and insert the spudger to remove it.
Step 5
- Continue to run the spudger along the crease to release any further clips that may still be attatched.
- Do no pull off the panel too fast because you don’t want to damage the ribbon cable. Slowly pull away the panel.
- Now that the front panel has been released from its clips you can pull off the front panel.
Continue to run the spudger along the crease to release any further clips that may still be attatched.
Do no pull off the panel too fast because you don’t want to damage the ribbon cable. Slowly pull away the panel.
Now that the front panel has been released from its clips you can pull off the front panel.
Step 6
- Find the brown section where the ribbon cable enters the green board. Flip the brown part up and pull out the plastic tab at the end of the ribbon.
Find the brown section where the ribbon cable enters the green board. Flip the brown part up and pull out the plastic tab at the end of the ribbon.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 3 other contributors
Sarah
Member since: 01/30/2014
1,675 Reputation
4 Guides authored
Badges:
15
+12 more badges
Team
Cal Poly, Team 2-11, Amido Winter 2014
Member of Cal Poly, Team 2-11, Amido Winter 2014
CPSU-AMIDO-W14S2G11
4 Members
31 Guides authored
braxton.taylor25 - Jul 19, 2020
Reply
Where can I find a new ribbon cable for Xbox 360 e? In addition, can very minuscule damage to cable cause the power button to turn red?