Difficulty

Easy

Steps

6

Time Required

                          2 minutes

Sections

1

  • Bottom Vent
  • 6 steps

Flags

0

  • BackXbox 360

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Vent
  • Stand the console vertically with the bottom edge facing up.
  • Throughout the following opening procedure, the finger of an Xbox 360 opening tool can be used in place of a spudger.
  • Insert the flat end of a spudger or the edge of an Xbox 360 opening tool into the small gap at the front edge of the bottom vent.
  • Pry the front edge of the bottom vent away from the faceplate.

Stand the console vertically with the bottom edge facing up.

Throughout the following opening procedure, the finger of an Xbox 360 opening tool can be used in place of a spudger.

Insert the flat end of a spudger or the edge of an Xbox 360 opening tool into the small gap at the front edge of the bottom vent.

Pry the front edge of the bottom vent away from the faceplate.

1024

Step 2

  • In the next few steps, you will use the tip of a spudger or the finger of an Xbox 360 opening tool to release the clips along the left and right sides of the bottom vent. Their locations are highlighted in red.
  • You will insert the tool into the holes molded into the white plastic side case pieces.

In the next few steps, you will use the tip of a spudger or the finger of an Xbox 360 opening tool to release the clips along the left and right sides of the bottom vent. Their locations are highlighted in red.

You will insert the tool into the holes molded into the white plastic side case pieces.

Step 3

  • To release the clips, work from the front edge of the bottom vent.
  • While slightly lifting the front edge of the bottom vent, use the tip of a spudger to push the clips closest to the front of the bottom vent towards the inside of the console.

To release the clips, work from the front edge of the bottom vent.

While slightly lifting the front edge of the bottom vent, use the tip of a spudger to push the clips closest to the front of the bottom vent towards the inside of the console.

Step 4

  • Repeat the same process to release the two center clips on the bottom vent.

Repeat the same process to release the two center clips on the bottom vent.

Step 5

  • Use the tip of your spudger to release the clips on the bottom vent nearest the back of the Xbox.

Use the tip of your spudger to release the clips on the bottom vent nearest the back of the Xbox.

Step 6

  • Remove the bottom vent from the 360.

Remove the bottom vent from the 360.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      65 other people completed this guide.

Author

                                      with 5 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges

exavier smith - Sep 20, 2017

Reply

cool thanks for the tip