Difficulty
Moderate
Steps
4
Time Required
10 minutes
Sections
1
- Server Board
- 4 steps
Flags
0
BackWorld Dryer Airforce J4-973A3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Server Board
- Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.
- The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.
Begin by removing both screws and the brushed metal casing. Simply lift up at the indicated area with your hand.
The INSTALL and REMOVE indicators may be incorrect, so exercise caution when removing the screws.
1024
Step 2
- Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.
- Lift the grey belt away. This gives access to the server board.
Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.
Lift the grey belt away. This gives access to the server board.
Step 3
- Remove all three 1/2" Ph1 screws connecting the server board to the device.
- During reassembly, install the screws before reattaching the wires.
Remove all three 1/2" Ph1 screws connecting the server board to the device.
During reassembly, install the screws before reattaching the wires.
Step 4
- Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board.
- Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires.
- After these steps, the server board should easily come off the side of the device.
Use a plastic opening tool to remove the two pink capped wires in the upper left corner of the server board.
Use the same tool to dislodge the white capped ribbon bus with the multi-colored wires.
After these steps, the server board should easily come off the side of the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Blane Hirsh
Member since: 09/17/2018
260 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Washington State, Team S1-G6, Hope Fall 2018
Member of Washington State, Team S1-G6, Hope Fall 2018
WSU-HOPE-F18S1G6
4 Members
4 Guides authored