Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

1

  • Sensor Board
  • 5 steps

Flags

0

  • BackWorld Dryer Airforce J4-973A3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Sensor Board
  • In order to change the air filter, start with the removal of the outer metal casing.
  • Using the special bit, remove the large screws at the bottom of the casing.
  • To remove the case, lift the indicated spot with your hands.
  • The direction for turning the screws is different than what was indicated on the small sticker above the hole.

In order to change the air filter, start with the removal of the outer metal casing.

Using the special bit, remove the large screws at the bottom of the casing.

To remove the case, lift the indicated spot with your hands.

The direction for turning the screws is different than what was indicated on the small sticker above the hole.

1024

Step 2

  • Remove the 1/2" Ph1 screws at the bottom of the red fan cap.
  • Turn over the unit.
  • Push the red tabs on the back of the unit with medium to heavy pressure, using a plastic opening tool.
  • Carefully remove the cap, to prevent damage to the sensor.

Remove the 1/2" Ph1 screws at the bottom of the red fan cap.

Turn over the unit.

Push the red tabs on the back of the unit with medium to heavy pressure, using a plastic opening tool.

Carefully remove the cap, to prevent damage to the sensor.

Step 3

  • Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.
  • Lift the grey belt away. This gives access to the server board.

Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.

Lift the grey belt away. This gives access to the server board.

Step 4

  • Remove the rainbow ribbon cable from the middle circuit board, using a plastic opening tool.
  • Remove the 1/2" Ph1 screw from the center of the circuit board.

Remove the rainbow ribbon cable from the middle circuit board, using a plastic opening tool.

Remove the 1/2" Ph1 screw from the center of the circuit board.

Step 5

  • Carefully remove the sensor board from your device.

Carefully remove the sensor board from your device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Luke Clancy

Member since: 09/17/2018

123 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Washington State, Team S1-G6, Hope Fall 2018                        

                                                  Member of Washington State, Team S1-G6, Hope Fall 2018 



                    WSU-HOPE-F18S1G6                     


                                            4 Members                     


                                            4 Guides authored