Difficulty

Very easy

Steps

5

Time Required

                          15 minutes

Sections

1

  • Wolfgang Puck Pie Maker Disassembly
  • 5 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackWolfgang Puck Pie Maker

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Wolfgang Puck Pie Maker Disassembly
  • Open up the pie maker using the two main handles so it’s open as shown in the picture.

Open up the pie maker using the two main handles so it’s open as shown in the picture.

1024

Step 2

  • Remove the four 12.7 mm screws from each handle using a Phillips #2 screwdriver.
  • Remove the inside handle cover.

Remove the four 12.7 mm screws from each handle using a Phillips #2 screwdriver.

Remove the inside handle cover.

Step 3

  • Remove the two 12.7 mm screws from the base of the pie maker using a Phillips #2 screwdriver.
  • This will allow for visibility into the wiring in the base.

Remove the two 12.7 mm screws from the base of the pie maker using a Phillips #2 screwdriver.

This will allow for visibility into the wiring in the base.

Step 4

  • Remove the four 15.9 mm screws from the hinges using a Phillips #2 screwdriver.
  • Remove the top cover by pulling it off of the device.

Remove the four 15.9 mm screws from the hinges using a Phillips #2 screwdriver.

Remove the top cover by pulling it off of the device.

Step 5

  • You now have access to the wiring underneath the top and bottom of the device.
  • To access the wiring, lift the metal burner part out of the base. The wiring will be visible on the opposite side, attached to the heating coil.
  • The temperature sensor can be accessed by lifting the bottom side of the device as shown.

You now have access to the wiring underneath the top and bottom of the device.

To access the wiring, lift the metal burner part out of the base. The wiring will be visible on the opposite side, attached to the heating coil.

The temperature sensor can be accessed by lifting the bottom side of the device as shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Jake D. Freedman

Member since: 09/16/2020

171 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Tufts University School of Engineering, Team S1-G9, Bell Fall 2020                        

                                                  Member of Tufts University School of Engineering, Team S1-G9, Bell Fall 2020 



                    TUFTS-BELL-F20S1G9                     


                                            2 Members                     


                                            1 Guide authored