Wolf Gourmet Wgtr102S Outer Shell Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          15 - 25 minutes            

Sections

1

• Outer Shell
• 8 steps

Flags

0

• BackWolf Gourmet WGTR102S

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Outer Shell               

• Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

1024

Step 2

• Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

Step 3

• Remove the crumb collector located on the bottom of the toaster.

Remove the crumb collector located on the bottom of the toaster.

Step 4

• Remove the three 8mm screws using the Tri-point Y1 screwdriver.

Remove the three 8mm screws using the Tri-point Y1 screwdriver.

Step 5

• Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.
• Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.

Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

Step 6

• Remove the final 8mm screw in the slide lever.
• The lever can now pull away from the entire unit.

Remove the final 8mm screw in the slide lever.

The lever can now pull away from the entire unit.

Step 7

• Remove toaster’s outer shell by lifting straight up.
• Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

Remove toaster’s outer shell by lifting straight up.

Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

Step 8

• Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.
• Remove the outer shell from the device.

Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.

Remove the outer shell from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Ryan Funchess                     

Member since: 04/19/2018

697 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team S22-G5, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S22-G5, Maness Spring 2018 



                    CPSU-MANESS-S18S22G5                     


                                            4 Members                     


                                            5 Guides authored