Difficulty

Moderate

Steps

11

Time Required

                          15 - 20 minutes

Sections

2

  • Outer Shell
  • 8 steps
  • Electrical Connection
  • 3 steps

Flags

0

  • BackWolf Gourmet WGTR102S

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Shell
  • Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

1024

Step 2

  • Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

Step 3

  • Remove the crumb collector located on the bottom of the toaster.

Remove the crumb collector located on the bottom of the toaster.

Step 4

  • Remove the three 8mm screws using the Tri-point Y1 screwdriver.

Remove the three 8mm screws using the Tri-point Y1 screwdriver.

Step 5

  • Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.
  • Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.

Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

Step 6

  • Remove the final 8mm screw in the slide lever.
  • The lever can now pull away from the entire unit.

Remove the final 8mm screw in the slide lever.

The lever can now pull away from the entire unit.

Step 7

  • Remove toaster’s outer shell by lifting straight up.
  • Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

Remove toaster’s outer shell by lifting straight up.

Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

Step 8

  • Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.
  • Remove the outer shell from the device.

Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.

Remove the outer shell from the device.

Step 9

              Electrical Connection
  • Unscrew the ground wire using a Tri-point Y1 screwdriver. It is secured with an 8mm screw.

Unscrew the ground wire using a Tri-point Y1 screwdriver. It is secured with an 8mm screw.

Step 10

  • Use pliers to pull apart the three electrical connectors pictured in the graphic.

Use pliers to pull apart the three electrical connectors pictured in the graphic.

Step 11

  • Replace the electrical connectors.

Replace the electrical connectors.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Ryan Funchess

Member since: 04/19/2018

697 Reputation

                                      5 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team S22-G5, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S22-G5, Maness Spring 2018 



                    CPSU-MANESS-S18S22G5                     


                                            4 Members                     


                                            5 Guides authored