Wolf Gourmet Wgbl100S Control Board Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          10 - 20 minutes            

Sections

1

• Control Board
• 7 steps

Flags

0

• BackWolf Gourmet WGBL100S

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Control Board               

• Flip the base of the blender upside-down.
• Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

Flip the base of the blender upside-down.

Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

1024

Step 2

• Using the metal spudger, pry off one half of each rubber foot.
• Note that one side of the foot is glued down; pry off the other side.

Using the metal spudger, pry off one half of each rubber foot.

Note that one side of the foot is glued down; pry off the other side.

Step 3

• Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
• Pull the base off of the blender.

Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.

Pull the base off of the blender.

Step 4

• Pull off the plastic housing.

Pull off the plastic housing.

Step 5

• Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

Step 6

• Using pliers, pull off all the connectors on the top.

Using pliers, pull off all the connectors on the top.

Step 7

• Pull or pry off the last connector block, then remove the control board.

Pull or pry off the last connector block, then remove the control board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 

                    Cole Gillespie                     

Member since: 04/19/2018

476 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team S25-G16, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S25-G16, Maness Spring 2018 



                    CPSU-MANESS-S18S25G16                     


                                            4 Members                     


                                            5 Guides authored