Difficulty

Easy

Steps

3

Time Required

Suggest a time??

Sections

1

  • Rotary switch
  • 3 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackWMF Kult Pro Reparatur

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              Rotary switch               
  • Carefully block the fan with a thin screwdriver. It is best to do this so that the screwdriver also finds resistance somewhere behind the fan.
  • Place the glass vessel, cover the blade with a cloth and turn it clockwise until the thread starts to loosen. Remove the container and unscrew the driver by hand.
  • Now loosen the three screws on the bottom of the mixer (marked in red) using a tensioner bit and a thin extension. Alternatively, you can also work a slotted screwdriver so that it fits on the screw.

Carefully block the fan with a thin screwdriver. It is best to do this so that the screwdriver also finds resistance somewhere behind the fan.

Place the glass vessel, cover the blade with a cloth and turn it clockwise until the thread starts to loosen. Remove the container and unscrew the driver by hand.

Now loosen the three screws on the bottom of the mixer (marked in red) using a tensioner bit and a thin extension. Alternatively, you can also work a slotted screwdriver so that it fits on the screw.

1024

Step 2

  • Lift the upper part of the housing. Remove the power supply connector (marked red) with pliers. Also, disconnect the connection to the control board (marked blue). Now you can lift off the housing.
  • Now loosen the four screws of the control board and lift it upwards out of its position.
  • The transparent plastic part above the LEDs (marked green) will probably come loose. It is best to take a close look at the construction, this may save some guesswork when reassembling.

Lift the upper part of the housing. Remove the power supply connector (marked red) with pliers. Also, disconnect the connection to the control board (marked blue). Now you can lift off the housing.

Now loosen the four screws of the control board and lift it upwards out of its position.

The transparent plastic part above the LEDs (marked green) will probably come loose. It is best to take a close look at the construction, this may save some guesswork when reassembling.

Step 3

  • To fix the problem with the rotary switch, the yellow marked white lugs must be flattened with a knife or file.
  • To do this, it is best to detach the entire inner part of the rotary switch from the circuit board. To do this, remove the two screws marked in red.

To fix the problem with the rotary switch, the yellow marked white lugs must be flattened with a knife or file.

To do this, it is best to detach the entire inner part of the rotary switch from the circuit board. To do this, remove the two screws marked in red.

Work through the steps in reverse order to reassemble your device. When they are all seated correctly, the parts interlock without tension.

Cancel: I did not complete this guide.

        shingle is helping us fix the world!      Want to contribute?      Start translating › 

Special thanks to these translators:

100%

shingle

Author

                                      with 1 other contributor 

                    Frederik Lamping                     

Member since: 02/20/2021

631 Reputation

                                      6 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges