Difficulty

Moderate

Steps

4

Time Required

                          15 - 20 minutes

Sections

1

  • Wire
  • 4 steps

Flags

2

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

  • BackNerf N-Strike Nite Finder EX-3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Wire
  • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
  • Remove the battery door and take the batteries out.

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

Remove the battery door and take the batteries out.

1024

Step 2

  • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
  • Lift the side of the blaster off exposing its internal parts.

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

Lift the side of the blaster off exposing its internal parts.

Step 3

  • Visually inspect all the wires in order to find the break, fray, or other problem.
  • Locate the end connections of the affected wire.

Visually inspect all the wires in order to find the break, fray, or other problem.

Locate the end connections of the affected wire.

Step 4

  • Use a hot soldering iron to melt the solder at one end of the wire until the wire can be pulled free from the connection.
  • Repeat on the other end of the connection to remove the wire from the blaster.
  • (End points marked on image are for the black wire)

Use a hot soldering iron to melt the solder at one end of the wire until the wire can be pulled free from the connection.

Repeat on the other end of the connection to remove the wire from the blaster.

(End points marked on image are for the black wire)

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Kyle Schober

Member since: 02/24/2014

640 Reputation

                                      5 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       Michigan Tech, Team 5-8, Lauer Spring 2014                        

                                                  Member of Michigan Tech, Team 5-8, Lauer Spring 2014 



                    MTU-LAUER-S14S5G8                     


                                            3 Members                     


                                            13 Guides authored