Difficulty
Moderate
Steps
10
Time Required
2 - 3 minutes
Sections
1
- Wire Bonder Thread Spool Replacement
- 10 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackWire Bonder
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Video Overview
Step 1
Wire Bonder Thread Spool Replacement
- Remove the seal from the wire spool. Take care not to cut the thread at the red marking!
Remove the seal from the wire spool. Take care not to cut the thread at the red marking!
1024
Step 2
- Insert the spool in the assembly.
- Make sure that the spool runs clockwise.
Insert the spool in the assembly.
Make sure that the spool runs clockwise.
Step 3
- Pull the thread downward.
Pull the thread downward.
Step 4
Placing the thread into the infeeder
- Place the thread between the guides of the infeeder.
- Pull the engaging knob which is situated to the left of the infeeder rolls, to the left.
- Now there is a gap between the infeeder rolls into which the wire can be inserted safely.
Place the thread between the guides of the infeeder.
Pull the engaging knob which is situated to the left of the infeeder rolls, to the left.
Now there is a gap between the infeeder rolls into which the wire can be inserted safely.
Step 5
Placing the thread behind the sensors
- Cut the wire.
- Place the wire behind the sensors (the black box in the foreground).
Cut the wire.
Place the wire behind the sensors (the black box in the foreground).
Step 6
Placing the thrad in the outfeeder
- Use the tweezers to place the wire between the two metal guides of the outfeeder.
Use the tweezers to place the wire between the two metal guides of the outfeeder.
Step 7
Put the wire into the tube
- Use the tweezers to lead the wire into the tube from below.
Use the tweezers to lead the wire into the tube from below.
Step 8
Automatic feeding
- Push the spring of the outfeeder and the “Feed and Capture” button simultaneously for automatic feeding.
- Make sure that the rolls of the outfeeder are close together so that the wire is gripped firmly.
- Before starting automatic feeding, turn off “Run or Service” and activate “Feed or Capture”.
Push the spring of the outfeeder and the “Feed and Capture” button simultaneously for automatic feeding.
Make sure that the rolls of the outfeeder are close together so that the wire is gripped firmly.
Before starting automatic feeding, turn off “Run or Service” and activate “Feed or Capture”.
Step 9
Manual Feeding
- It is also possible to feed the wire manually into the outfeeder tube.
- In order to do so, press the “Run and Service” button and turn the left-hand wheel clockwise. The wire is now fed ino the tube.
It is also possible to feed the wire manually into the outfeeder tube.
In order to do so, press the “Run and Service” button and turn the left-hand wheel clockwise. The wire is now fed ino the tube.
Step 10
- Check visually if the wire is fed into the bonding head.
Check visually if the wire is fed into the bonding head.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Beate Richter
Member since: 03/20/2019
181 Reputation
1 Guide authored
Badges:
2