Difficulty
Easy
Steps
2
Time Required
3 minutes
Sections
1
- Battery
- 2 steps
Flags
0
BackNintendo Wii U GamePad
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
- Lift up and remove the battery cover.
Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
Lift up and remove the battery cover.
1024
Step 2
- With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
- Pull upwards from the bottom of the battery to release it.
With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
Pull upwards from the bottom of the battery to release it.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
13 other people completed this guide.
Author
with 6 other contributors
Kim Arre
Member since: 01/11/2013
4,403 Reputation
8 Guides authored
Badges:
20
+17 more badges
Team
Cal Poly, Team 17-20, Forte Winter 2013
Member of Cal Poly, Team 17-20, Forte Winter 2013
CPSU-FORTE-W13S17G20
5 Members
28 Guides authored
roof tip - Nov 21, 2013
Reply
I only see two pins on most 3rd party rechargeable Li-Ion batteries. What is the pinout for the factory supplied battery? I would like to replace the battery with a similar 3.7v Li-Ion battery from somewhere like adafruit.
I found an answer to my first question. My follow up question is if you can use a battery with only two charging pins and not the temp sensor pins?
Steven Chiu - Nov 25, 2013
Reply
There’s no reason you can’t but without the temp sensor you must be cautions if your battery does over heat because it can lead to damages on the touchscreen as well.
Chris - Jan 12, 2016
Reply
Why does Nintendo mention a size #0 screwdriver while iFixit says #00?
proof: http://en-americas-support.nintendo.com/…
“•Use a crosshead style, size #0 screwdriver to avoid damage to the screw or threads”
“2.Loosen the battery cover screws with a crosshead style, size #0 screwdriver.”
/a confused person
Kim Arre - Jan 13, 2016
The size #00 is just a little smaller than the #0. When we wrote these guides, we used whatever worked for us. Either should work, but generally you should use the largest that will work to avoid stripping the screw.