Difficulty
Moderate
Steps
11
Time Required
30 - 45 minutes
Sections
5
- Foot
- 4 steps
- Back Cover
- 2 steps
- Battery Case
- 2 steps
- Front Cover
- 2 steps
- Power Supply
- 1 step
Flags
0
BackWii Balance Board
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Unscrewing the Foot Cover
- Flip device upside-down so the plastic white board is facing the ground.
- Locate the four feet in the corners of the Balance Board.
- Unscrew the three 12.7 mm Phillips screws from each foot cover.
Flip device upside-down so the plastic white board is facing the ground.
Locate the four feet in the corners of the Balance Board.
Unscrew the three 12.7 mm Phillips screws from each foot cover.
1024
Step 2
Removing the Foot Cover
- Remove the gray plastic ring from the actual foot by lifting it up.
Remove the gray plastic ring from the actual foot by lifting it up.
Step 3
Removing the Foot
- Separate the loose foot from the device by lifting it up.
Separate the loose foot from the device by lifting it up.
Step 4
Removing the Additional Feet
- Repeat steps two and three on the remaining four feet.
Repeat steps two and three on the remaining four feet.
Step 5
Unscrewing the Back Cover
- Unscrew the ten 12.7 mm Phillips #1 screws.
Unscrew the ten 12.7 mm Phillips #1 screws.
Step 6
Removing the Back Cover
- Lift off the gray back cover.
Lift off the gray back cover.
Step 7
Battery Compartment
- Locate the gray battery compartment.
- Push the tab on the bottom and lift up completely to remove the cover to the batteries.
Locate the gray battery compartment.
Push the tab on the bottom and lift up completely to remove the cover to the batteries.
Step 8
Removing the Battery Case
- Unscrew the two 6.35 mm Phillips #1 screws.
- Slide the battery case out.
Unscrew the two 6.35 mm Phillips #1 screws.
Slide the battery case out.
Step 9
Unscrewing the Frame
- Unscrew the four 12.7 mm #1 screws.
Unscrew the four 12.7 mm #1 screws.
Step 10
Removing the Frame
- Lift the frame, circuit board, and power supply out of the front case. These components are all connected.
Lift the frame, circuit board, and power supply out of the front case. These components are all connected.
Step 11
Removing the Power Supply
- Lift out the power supply. It is not screwed in.
Lift out the power supply. It is not screwed in.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Cory Olson
Member since: 09/29/2014
849 Reputation
4 Guides authored
Badges:
16
+13 more badges
Team
Cal Poly, Team 13-8, Forte Fall 2014
Member of Cal Poly, Team 13-8, Forte Fall 2014
CPSU-FORTE-F14S13G8
5 Members
15 Guides authored