Difficulty
Easy
Steps
3
Time Required
5 minutes
Sections
1
- Keyboard
- 3 steps
Flags
2
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
Better Introduction
Improve this guide by completing or revising its introduction.
Backwhy! (Eluktronics) N131WU Laptop
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Keyboard Screws
- Remove the two keyboard retaining screws.
Remove the two keyboard retaining screws.
1024
Step 2
Unclip the Keyboard
- Insert a small screwdriver into the holes the screws were removed from in the previous step to unclip the keyboard.
Insert a small screwdriver into the holes the screws were removed from in the previous step to unclip the keyboard.
Step 3
Disconnect the Cables
- Using a plastic spudger, flip up the retaining latch on the ZIF connector securing the blue ribbon cable, then slide the cable straight out from the connector.
- To release the orange flex cable, use the tip of a spudger to slide the latches on either side in the direction indicated by the arrows, then pull the cable straight out from the connector.
Using a plastic spudger, flip up the retaining latch on the ZIF connector securing the blue ribbon cable, then slide the cable straight out from the connector.
To release the orange flex cable, use the tip of a spudger to slide the latches on either side in the direction indicated by the arrows, then pull the cable straight out from the connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
These translators are helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
Lorenzo
Jerry W
Author
with 1 other contributor
Felice Suglia
Member since: 06/15/2013
28,552 Reputation
243 Guides authored
Badges:
20
+17 more badges